Application of Design of Experiments and Grey Analysis to Optimize the Surface Roughness Quality of AISI 4340 Steel in Turning Using TiN Tools
Volume 2, Issue 2, Summer 2012, Pages 71-77
Saman Khalilpour Azari, Payam Nasib
Abstract Nowadays, competition in various industries focuses on reducing production waste and improving the quality of manufactured products. In this article, the improvement of surface roughness quality of AISI 4340 workpieces in the turning process using TiN-coated carbide tools is investigated. For this purpose, the parameters affecting the surface quality, namely cutting speed, feed rate, and depth of cut, were selected as the input factors for the experiments. Then, the degrees of freedom of the system and the required number of levels were determined, and the corresponding orthogonal arrays were calculated. Accordingly, twenty-seven experiments were designed to measure the surface roughness values, and for each experiment, three measurements of the surface roughness parameter were recorded. Next, by calculating the grey ratios, grey coefficients, and grey grades using the relevant formulas, the final grey relational graphs were plotted for all three levels of the experiments. Based on the grey relational diagram, the percentage influence of each input parameter on achieving the desired surface roughness was determined, and the optimal numerical values for these parameters were identified. A comparison of the grey analysis results with the actual experimental data confirms the accuracy and capability of this method in predicting surface roughness in the turning process.
Application of Design of Experiments to Investigate the Effects of Highway Traffic Control Strategies
Volume 2, Issue 1, Spring 2012, Pages 27-36
Nastaran Farkhnia, Hamidreza Eskandari
Abstract Traffic smoothing from an economic perspective, traffic management considerations, and the reduction of environmental pollutants are critical issues in large metropolitan areas. This paper analyzes the traffic problem of a congested freeway network by integrating microscopic traffic simulation with Design of Experiments (DoE) to investigate the effects of highway traffic control strategies.
To manage network traffic, two strategies—ramp metering and lane blocking—are employed. These strategies have recently been implemented on Tehran’s freeways using police vehicles to reduce the volume of incoming traffic to the main freeway.
To evaluate traffic-smoothing strategies, the effects of six decision variables, three variables representing the occurrence of lane blocking near three entrance ramps, and three variables representing ramp metering activation at these ramps, on two performance measures (average speed and total network throughput) are examined using a two-level factorial experimental design.
A total of 64 experimental scenarios were executed in the Aimsun microscopic simulation software, and the outputs were analyzed in Minitab to assess the significance of main and interaction effects of the decision variables. Finally, a regression model was fitted for each performance measure.
The application of Design of Experiments provides enhanced insights into the impacts of traffic-smoothing strategies and opens new avenues for the combined use of these strategies to improve traffic flow.
